All surfaces to be covered shall be structurally sound, clean and free from traces of dust, oil, grease, wax, paint, curing agent, coatings and loose particles. They must also be exempt from any trace or presence of acids, concentrated alkalis, chemical cleaning agent or any other material that can reduce adhesion.

All concrete substrates shall be completely cured and at least 28 days old. They must be roughened for a good adhesion and to remove completely all traces of paint, coating, loosely bonded toppings, loose particles and construction debris.

Saturate concrete surface with clean water within few hours before repairs leaving no excess water and apply mortar when surface is dry again. Use of Eagle Prime Plus as primer is a good alternative to concrete water saturation.

Ambient, surface and product temperature must be superior than 10ºC (50ºF) and lower than 35ºC (95ºF) before installation and for the first 24 hours. Avoid working under intense sun.

In a clean container, pour 170 ml of fresh clean water per kilogram of product. Add gradually Eagle RapidFix powder while mixing with a low-speed drill and a mixer.

Blend for 1 to 2 minutes scraping recipient walls and paddle to obtain a homogeneous trowelable lump-free consistency.

Proceed rapidly for application and finishing. Blend only quantities that can be applied in about 10 to 15 minutes.

Clean working tools and hands with water while product is still fresh.

Eagle Rapid Fix takes 15 to 35 minutes to dry. Curing time may vary according to temperature and humidity level. Protect surface from rain, sun and wind. Protecting job against weather, with a plastic sheeting in example, must be done without any contact with the surface as it could alter the finish. Wait from 2 to 3 hours prior to allow light traffic.