All surfaces to be covered shall be structurally sound, clean and free from traces of dust, oil, grease, wax, paint, curing agent, coatings and loose particles. They must also be exempt from any trace or presence of acids, concentrated alkalis, chemical cleaning agent or any other material that could reduce adhesion.

The only wood substrate recommended is new exterior grade plywood installed on interior floor in dry areas.

All concrete substrates shall be completely cured and at least 28 days old. They must be roughened for a better adhesion.

Ambient, surface and product temperature must be superior than 10ºC (50ºF) and lower than 35ºC (95ºF) during application and for the first hours. Avoid working under intense sun.

Shake well before use. Eagle Prime Plus is ready to use; do not dilute.

In presence of very porous substrate, it could be necessary to apply two coats .

Apply a generous coat with a brush or a roller.

Clean working tools and hands with water while product is still fresh.

A repair mortar must be applied while latex application is still humid, without any accumulations. If primer has partially dried, proceed with another application. Curing time may vary according to temperature and humidity level. Protect surface against rain, sun and wind.

Store in a dry and fresh area. Keep from freezing. Shelf life is 12 months in its original non-opened container.