All surfaces to be covered shall be structurally sound, clean and free from traces of dust, oil, grease, wax, paint, curing agent, coatings and loose particles. They must also be exempt from any trace or presence of acids, concentrated alkalis, chemical cleaning agent or any other material that can reduce adhesion.

All concrete substrates shall be completely cured and at least 28 days old. They must be roughened to completely remove all traces of paint, coating, loosely bonded toppings, loose particles and construction debris.

Saturate concrete surface with clean water within few hours before repairs leaving no excess water and apply mortar when surface is dry again. Use of Eagle Prime Plus as primer is a good alternative to concrete water saturation.

Ambient, surface and product temperature must be superior than 10ºC (50ºF) and lower than 35ºC (95ºF) before the installation and for the first 72 hours. Avoid working under intense sun.

Some jobs may need the use of forms to hold ground, like column bases. Forms can be taken apart after a minimum of 3 days.

In a clean container, depending on desired consistency, pour 140 ml to 180 ml of fresh clean water per kilogram of product and gradually add Eagle Grout powder while mixing with a low-speed drill and a mixer.

Blend for 2 to 3 minutes scraping recipient walls and paddle to obtain a homogeneous pourable lump-free consistency.

Proceed immediately to application.

Clean working tools and hands with water while product is still fresh.

Eagle Grout takes 1 to 2 hours to dry depending on consistency. Drying may vary according to temperature and humidity level. Protect surface from rain, sun and wind. As soon as product starts to set, keep surface moisten with damp burlap, cover with plastic sheeting and allow a 72 hours curing.