Eagle Black
Eagle Garapoxy: Epoxy Coating for Floor
Description
Eagle Garapoxy is a two component, no VOC, 100% solids, low odor epoxy coating specially formulated for garage and warehouse floors. This paint is formulated to protect concrete against deicing salts, grease, oil, tire marks, chemical products and others, for residential, commercial and industrial uses. This industrial grade coating is easy to apply, easy to clean and gives exposition showroom look. Eagle Garapoxy is offered in 6 colors either green, blue, yellow, beige, grey or charcoal.
Surface Preparation

All surfaces to be cover shall be structurally sound, clean, dry and free from traces of dust, laitance, oil, grease also be exempt from any trace or presence of acids, concentrated alkalis, chemical cleaning agent or any other material that can reduce adhesion. It is required to degrease concrete surfaces with a good cleaner / degreaser.
All concrete substrates shall be completely cured and at least 28 days old. Concrete substrate must have a humidity level lower than 4% before to apply epoxy.
Ambient, surface and product temperature must be superior to 10ºC (50ºF) lower than 30ºC (95ºF) before the installation and for the first hours.

Mixing

Pour component B in component A container. Carefully mix at a low speed using a drill fit with and agitator.
Mix for 2 to 3 minutes, scraping container walls and agitator to obtain an homogeneous mix.

APPLICATION

Apply immediately with an epoxy paintbrush or roller.

Curing

A second coat can be applied taking care not to exceed 24 hours after first application. Temperature and humidity are critical factors that can vary drying time and can alter gloss and/or color. Garapoxy takes 24 hours of curing for light foot traffic and 7 days for complete cure. Make sure application is dry before to allow light traffic

Approximate coverage for a 3.78L Pail :

Coverage of Garapoxy can vary from 11.6 to 18.6 m² ( 125 to 200 pi²), depending on concrete surface porosity and roughness.

Package

Available in bag of 22.7 kg.

Storage

Store in a fresh and dry area. Shelf life is 12 months in its original non-open container.

Clean up

Clean tools and hands with warm water and soap while the material is still fresh

Eagle Black

 


WARNING Simdut


IRRITANT (COMPOSANT A)

This product contains a resin that can cause skin or eye irritation. May cause allergic skin reaction. Wear protective gloves and eye/face protection. Do not breathe vapour. Wash thoroughly after handling. If medical advice is needed: Have product container or label at hand.
FIRST AID TREATEMENT: IF ON SKIN (or hair): Take off contaminated clothing and wash before re-use. Rinse skin with water and/or take a shower. Wash with plenty of soap and water. If skin irritation occurs, seek medical advice/attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to remove. Continue rinsing. If eye irritation persists, get medical advice/attention. Wash hands after handling. Get medical attention/advice if you feel unwell.

KEEP OUT OF REACH OF CHILDREN.

READ SAFETY DATA SHEET BEFORE USING THIS PRODUCT

Technical Data Table

CARACTERISTICS Eagle Garapoxy
Pot life 1 hour
Open time 8 to 10
Set time final ASTM C-191 24 to 48 hours

* Dry Time dependent of surface porosity and temperature.

 

 

Warranty

Condor certifies that this product is free from manufacturing defect and is of merchantable quality. Consumer shall verify the suitability of this product for the intended purpose. Because manufacturer has no control over proper surface preparation, method of application and applicator’s skill, no guarantee as to results is offered, expressed or implied. Therefore, we limit our liability to the replacement of the product judged defective. FOB plant.

WARNING Simdut


CORROSIVE
(COMPOSANT B)

This product contains a material that may causes skin and eyes irritation, it may cause respiratory irritation and it may cause allergic skin reaction. Harmful to aquatic life.
Wear protective gloves. Wear eye/face protection. Do not breathe vapour. Wash thoroughly after handling. If medical advice is needed: Have product container or label at hand.
FIRST AID TREATEMENT: IF ON SKIN (or hair): Take off contaminated clothing and wash before re-use. Rinse skin with water and/or take a shower. Wash with plenty of soap and water. If skin irritation occurs, seek medical advice/attention.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing, get medical advice/attention. Wash hands after handling. Get medical attention/advice if you feel unwell.

KEEP OUT OF REACH OF CHILDREN.
READ SAFETY DATA SHEET BEFORE USING THIS PRODUCT

 

PDFDownload PDF file format