All surfaces to be cover shall be structurally sound, clean and free from traces of dust, oil, grease, wax, paint, curing agent, coatings and loose particles. They must also be exempt from any trace or presence of acids, concentrated alkalis, chemical cleaning agent or any other material that can reduce adhesion.

All concrete substrates shall be completely cured and at least 28 days old. It must be roughened for more adhesion and to remove completely all traces of paint, coating, loosely bonded toppings, loose particles and construction debris.

Saturate concrete surface with clean water within few hours before repairs leaving no excess water and apply mortar when surface is dry again. Use of Eagle Prime Plus as primer is a good alternative to concrete water saturation.

Ambient surface and product temperature must be superior than 10ºC (50ºF) and lower than 35ºC (95ºF) before the installation and for the first 24 hours.

In a clean container, pour exactly 5.68 litres of fresh clean water and gradually add 22.7 kg of Eagle Econoplan powder while mixing with a low-speed drill and a mixer.

Blend for 2 to 3 minutes scraping recipient walls and paddle to obtain a homogeneous malleable and lump-free consistency is achieved.

Slake for 5 minutes and mix again for 1 minute. Apply immediately.

Clean working tools and hands with water while product is still fresh.

Protect application from any direct ventilation or heat radiation sources, such as direct sunlight during and after application for a minimum of 24 hours. These conditions could cause micro-cracking.

Eagle Plan takes 2 to 3 hours to set, depending on consistency and ambient conditions. Curing time may vary according to temperature and humidity level.
Wait 24 hours before light traffic.