All surfaces to be covered shall be structurally sound, clean and free from traces of dust, oil, grease, wax, paint, curing agent, coatings and loose particles. They must also be exempt from any trace or presence of acids, concentrated alkalis, chemical cleaning agent or any other material that could reduce adhesion.

All concrete substrates shall be completely cured and at least 28 days old. They must be roughened to offer good bonding.

Saturate concrete surface with clean water within few hours before repairs leaving no excess water and apply mortar when surface is dry again. Use of Eagle Prime Plus as primer is a good alternative to concrete water saturation.

Ambient, surface and product temperature must be superior than 10ºC (50ºF) and lower than 35ºC (95ºF) before the installation and for the first 24 hours. Avoid working under intense or midday sun.

In a clean container, pour 4/5 of latex and gradually add Eagle 2KTop powder while mixing with a low-speed drill and a mixer. For 6 mm to 12 mm (1/4” to ½”) application, use as is; for thinner applications, add the remaining of latex.

Blend for 2 to 3 minutes scraping recipient walls and paddle to obtain a homogeneous mixture lump-free consistency.

Slake for 5 minutes and mix again for 1 minute. Proceed to application and finishing.

Clean working tools and hands with water while product is still fresh.

Eagle 2KTop takes 2 to 5 hours to dry, depending on its consistency and ambient temperatures. Drying may vary according to temperature and humidity level. Protect surface from rain, sun and wind. Protecting job against weather, with a plastic sheeting in example, must be done without any contact with the surface as it could alter the finish. Wait 24 hours prior to allow light traffic.