Condor
CR-20 Plastic Cement Condor™
Description
CR20 is a multi-purpose asbestos free plastic cement . Use to fill holes and cracks on foundations, asphalt roofs, shingles, vent, chimney joints and others. Once dried, it becomes a strong waterproofed coating and resists against bad weather. Can be use to glue back asphalt shingles and protect them against wind.
Surface Preparation
Surfaces must be structurally sound, free of frost, dust, rust, chipped paint, oil, grease and any loose or deteriorated materials.
Application
Apply with a putty knife, a trowel , by hand with glove or with a caulking gun. To fill joints and cracks, push profoundly into gaps making bulge out on surface to avoid accumulation of water. Repair cracks, holes and by applying a coat of 3 mm (1/8 in.) thick to the defective sections and overtake of 150 mm (6 in.) around repairs. To stick back shingles, apply only 3 points of 25 mm (1 in.) evenly distributed. To facilitate low temperature applications, keep product in a warm place.
Clean up
Clean tools and equipment with mineral spirits.
Package
Available 4kg, 12kg and 20 kg
NORME
CAN/O.N.G.C. 37.5M-89
Shelf Life
12 months after purchasing date when kept in its tightly closed original container. 
Condor
Condor

Technical Data Table

  Specifications
Color Black
Solids by Volume 70 to 80%
Weight 1,21 kg/L (10,1 pounds/gal)
Coverage 0,32 m²/kg (3,45 ft²/kg) for 3 mm (1/8 in) coat
Dry Time*

To 50 % R.H. 20° C (68° F)

To the Touch* 4 hours
Completely Dry* 48 hours
Service Temperature Maximum : 85° C (185° F) dry coating
Application Temperature 10° C or more
Chemical Resistance

Resistant to water calcium chloride, salt and to lightly acid or alkaline solutions. Is not resistant to oils, greases and solvents.

Permeance to Water Vapor (ASTM E96) 3 mm (1/8 in) coat before drying 2.9 ng/Pa.m2.s (0.05 perms)
 

* Dry Time dependent of surface porosity and temperature.

Restrictions

If product is applied near a ventillation unit or an air conditioner, take necessary precautions to avoid solvent infiltration inside. For EXTERIOR USE only.

Warranty

The customer shall verify of the suitability of this product for the intended purpose. Applicator’s skill, weather and surface conditions being beyond manufacturer’s control, we limit our liability to replacement of defective material only in sealed container, within 1 year of proof of purchase. FOB plant.

Trowel Gun
Glove
Knife
Warning Simdut

Harmful and flammable liquid and vapors

Contains petroleum distillates. May cause dizziness, headache or nausea. May cause nose, throat, eyes and skin irritation. Keep away from heat sources, sparks and flames. Use only with adequate ventilation. Do not breathe vapors. Wear safety glasses and appropriate gloves.

FIRST AID: Eyes : In case of contact, flush immediately with plenty of water for at least 15 minutes and get medical attention immediately; for skin, wash thoroughly with soap and water. If you experience difficulty in breathing, leave the area to obtain fresh air. If difficulties continues, get medical assistance immediately. If swallowed, do not induce vomiting. Get medical attention immediately.

KEEP OUT OF REACH OF CHILDREN READ SAFETY DATA SHEET BEFORE USING THIS PRODUCT

 

PDFDownload PDF file format